Decoder

Start Decoder-Firmwareupdate:

Over here, the ZSP Decoderupdater start.
The prerequisite is that program with ZSP was also installed at the default location!

Decoder identify (only Fullversion):

Connect the decoder to the programming track of the MX10 (track 2) and start the identification.

Read decoder CV (only Fullversion):

Reading CVs are both on the main, and on the programming track of the MX10 in "POM" mode.

It is highly recommended during this procedure to perform any more control of the system, or vehicles!
CVs are only read by Zimo decoders that have RailCom active in CV29!
If either of these conditions are not fulfilled, the reading is not running - it was not recognized a ZIMO Decoder:

Once a ZIMO was detected, you can start the CV read:

It is the recognized ZIMO and the reading process reads:

Depending on the type of decoder, and recognized to be read CVs, the time it takes to read.

Can while reading one or more CVs are read, an error note:

The background of the status bar is RED, the window displays the message "Could not read all CVs!" displayed and it will open a window in which all not read CVs are displayed. One can now determine which CVs it is, whether its value is important, and decide whether you starts reading again, or waived and still performs the necessary configuration.

Decoder CV Write (only Fullversion):

Writing CVs are both on the main, and on the programming track of the MX10 in "POM" mode.

It is highly recommended during this procedure to perform any more control of the system, or vehicles!

Previously been no decoder read, must be described decoder type (travel, sound, switch decoder) can be selected:

If this is not done, the following error message:

One has the opportunity to write only the changed CVs, or independent of any change, all CVs.
Depending on the selected type of decoder, and thus descriptive CVs, writing takes different lengths.

ATTENTION!
The CV Writing and CV Reading in "live mode" is not possible!